Ensure the fiber cable is connected on both ends and the connected switch/router port is active.
enable configure terminal interface fastEthernet 0/0 ip address 192.168.1.2 255.255.255.0 no shutdown end media converter in cisco packet tracer link
A media converter is a Layer 1 (Physical Layer) networking device. It does not read IP addresses, MAC addresses, or make forwarding decisions like a switch or router. Instead, it simply converts the electrical signals from one cable type into optical (or different electrical) signals for another cable type. Ensure the fiber cable is connected on both
Router(config)# interface GigabitEthernet0/0/0 Router(config-if)# no shutdown 4. Verification Instead, it simply converts the electrical signals from
: Typically functions as a transparent bridge, meaning it does not require an IP address or complex CLI configuration to operate. Perle Systems How to Use the Media Converter
: Drag a 1941 or 2911 router onto the workspace.
A is a simple Layer 1 (Physical layer) device. It does not read IP addresses, MAC addresses, or make routing decisions. Its job is straightforward: