Comprehensive Guide to the Gordak 952 Hot Air Soldering Station
If the external meter reads lower than 350°C, turn the pot slowly clockwise. If the external meter reads higher than 350°C, turn the pot counter-clockwise.
Technical Overview and User Operations for the Gordak 952 Rework Station Gordak 952 gordak 952 user manual updated
Check the 5-pin connection. Inspect the main power fuse located at the back of the station near the power cord. Oxidized soldering tip or uncalibrated station.
Remove the red or silver shipping screws located on the bottom of the chassis. Comprehensive Guide to the Gordak 952 Hot Air
The front panel features dedicated zones for both tools, allowing for independent operation. Left Section: Hot Air Rework Controls Toggles power to the hot air system.
If the station displays an error, it is likely related to a faulty sensor or heater in either the gun or the iron. 5. Safety Precautions Inspect the main power fuse located at the
Rotate the temperature dial to your required thermal profile.
Adjusts the temperature of the soldering tip.
The air pump provides a stable, low-noise airflow, perfect for precise, delicate components.
Use a dedicated tip thermometer (such as a Hakko 191 or similar) to measure the actual temperature of the soldering tip or hot air stream.